The MGA With An Attitude
Replacing REAR HUB SEALS - RA-101-15

The first step in removing the flange from the Speedi-Sleeve is to make a small break in the flange. Best way to do that is to use a side cutter to make a small cut in the flange, most of the way from the edge to the root of the flange. Since the flange is only 0.010" thick, it doesn't take a lot of force to cut through it.

Breaking the flange on the Speedie-Sleeve
Thank you for your comments -- Send e-mail to <Barney Gaylord>
© 1998, 2007 Barney Gaylord -- Copyright and reprint information