The MGA With An Attitude
MGAguru.com MGAguru.com
COWL VENT for MGA -- FT-041
To Much Crown

MGA cowl vent
Two of this piece were procured from Moss Motors (part number 471-010) in June 2008. There is too much arch in the middle causing the sides to sit high so the part will rock back and forth if not secured. If held level when installing the Tinnerman fastener to equalize gaps at both sides it may look okay from 10 feet away. It did not fit well enough to suit me and my daily driver car, so I reinstalled the older ones purchased from Moss in 1986 (which do fit properly).
MGA cowl vents

HomeNext
Thank you for your comments -- Send e-mail to <Barney Gaylord>
© 2010 Barney Gaylord -- Copyright and reprint information