The MGA With An Attitude
BONNET BUFFER is Too Short -- FT-075
Moss Motors, USA part no: 281-630 (Buffer set)
Replacement for BMC  271601 or AAA4598 Buffer for bonnet lid.

On 1/19/2015, rob zucca wrote:
"I bought new ones from Moss along with the small screws nuts and washers. After installing, my bonnet sat too low. Flush at hinges and latch, but down in the middle. Cleaned up the originals, re fitted and bonnet fits flush. I gave Kelvin at Moss a heads up also. There is almost an eighth inch difference. Photo attached".

The current Moss Motors repacement part is too short. Moss has been notofied 1/19/2015.

Thank you for your comments -- Send e-mail to <Barney Gaylord>
© 2015 Barney Gaylord -- Copyright and reprint information